A refrigerator that suddenly stops cooling is never just an inconvenience — it’s a race against time before everything inside goes bad. For homeowners around Lake Travis and the greater Lakeway area, the good news is that most refrigeration problems have a clear cause and a straightforward fix, as long as the right technician looks at it.
This guide walks through what actually goes wrong with refrigerators and freezers, what a real repair visit should look like, and how to decide between repairing your unit or replacing it — all from the perspective of what Lakeway Appliance Repair sees on service calls every week.
A refrigerator looks simple from the outside, but it’s really three systems working together: a sealed refrigerant loop, an electrical control system, and a set of mechanical parts (fans, motors, valves) that all have to cooperate. When one piece fails, the rest of the unit often starts compensating in ways that hide the real problem.
That’s why guessing at a fix — replacing a part because it “seems right” — usually wastes money. A trained technician instead works backward from the symptom: checking amp draw on the compressor, measuring temperatures at the evaporator, and confirming refrigerant pressure before touching anything with a wrench. In the Texas Hill Country, where garage refrigerators and outdoor kitchen units deal with extreme summer heat, that diagnostic step matters even more, since heat stress can create symptoms that mimic two or three different failures at once.
This is the number one call. The cause is rarely one single thing — it’s usually near the top of this list:
A technician who checks each of these in order — rather than jumping straight to “you need a new compressor” — will usually find a cheaper fix than expected.
When frost coats the back wall or bottom of a freezer, the defrost system has stopped working. That system includes a heater, a thermostat (or thermistor), and a timer or control board that tells the heater when to turn on. If any one of those fails, ice keeps building until it blocks airflow entirely and the whole unit warms up.
With so many newer builds and remodels in Lakeway featuring French-door refrigerators, ice maker calls are common. The usual suspects are a frozen supply line behind the fridge, a bad water inlet valve, or an ice maker module that’s simply worn out after years of use.
A refrigerator that runs almost non-stop is working overtime to hold temperature — and it shows up on the electric bill fast. This is frequently traced back to a worn door seal letting warm air in, a thermostat that’s misreading the internal temperature, or coils so dirty the compressor can’t release heat efficiently.
Puddles inside the fridge usually trace back to a clogged defrost drain tube. Water collecting on the floor underneath is more often a cracked drain pan, a loose water-line fitting, or a door gasket that isn’t sealing all the way around.
A rattle, buzz, hum, or clicking noise is the appliance telling you something specific. A clicking sound every few minutes often points to a failing start relay. A buzzing hum can mean a fan blade is hitting ice buildup. Loud grinding usually means a motor bearing is on its way out. None of these get better on their own.
Homeowners in Lakeway deserve the same standard of service whether they’re calling about a fridge in a lakeside home or a second unit in a garage. Here’s what that standard should include:
If a company can’t check all four of these boxes, it’s worth calling someone else.
This is the question every technician gets asked, and the honest answer depends on two numbers: the age of your unit and the cost of the repair.
A widely used guideline: if your refrigerator is under 8–10 years old and the repair estimate comes in under half the price of a new comparable unit, repairing is almost always the smarter move. Refrigerators built in the last decade are often more efficient and more expensive to replace than people expect, which tips the math toward repair more often than not.
Once a unit passes the 10-year mark, or if it’s already had two or three major repairs, replacement starts to make more sense — especially if the repair estimate creeps close to half of what a new model would cost. A technician who’s upfront about this, even when it means less repair work for them, is one worth keeping on speed dial.
Most common repairs — a defrost thermostat, a start relay, a water inlet valve — fall in a moderate range, while compressor replacement or refrigerant work costs more due to the labor and parts involved. A technician should give you an exact number after diagnosing the unit, not before.
Most repairs are completed in a single visit, usually within one to two hours, once the part needed is confirmed and on hand.
No. Some cycling is normal, but a compressor that never rests is a sign something — coils, a door seal, or a thermostat — needs attention.
In many cases, yes, especially for common issues like fan motors, relays, or thermostats, provided the part is in stock. Same-day or next-day service is standard for a responsive local company.
Often, yes — many manufacturer warranties allow repairs from any licensed technician. It’s worth checking your warranty terms before scheduling, since some brands require using an authorized service provider.

Your Appliances, Our Expertise
Our highly trained repair experts deliver reliable, high-quality repair services backed by continuous training and industry expertise.
108 Ranch Rd 620 S, Lakeway, TX 78734
contact@lakewayappliancerepair.com